Why is Solaris always booting into the Device Configuration Assistant (DCA)?

• You installed Solaris onto a disk other than the primary boot disk.
  
• You didn't remove your DCA boot diskette or
  if you didn't remove your installation CD-ROM if it's in a bootable CD-ROM
  drive.
  
• File /boot/solaris/bootenv.rc is corrupt or truncated,
  usually after a hard reboot or reset.
  This file is setup and used by DCA.
  It should contain several lines.
  

To change or set your default boot device,
See Sun FAQ 2271-02 at
http://access1.Sun.COM/cgi-bin/rinfo2html?227102.faq
for instructions.
To summarize:

• From the "Boot Solaris" screen, press F4 (Boot Tasks).
  
• On the "Boot Tasks" screen, press Enter to place an "X" in
  front of "View/Edit Autoboot Settings."
  
  
• In the "View/Edit Autoboot Settings" screen, note that the
  Default Boot Device will not be set to any valid device.
  Place an "X" in front of Set Default Boot Device and press
  F2 (Continue).
  
• On the Set Default Boot Device screen, place an X in front of the
  correct disk and press F2 (Continue).
  
• Arrow up to the Accept Settings and press Enter to mark with an "X".
  Press F2 (Continue) to return to the Boot Tasks screen.
  
• Press F3 (Back). It will load appropriate drivers after which you
  will be at the Boot Solaris screen. Press F2 (Continue) to continue
  booting.
  

[an error occurred while processing this directive]